Increase audio volume
Make a quiet recording louder by a fixed amount of gain, then save it in its original format. Private and done in your browser.
Runs on your device. Your file never leaves it.
Preset for this page
- Input
- Audio
The tool below starts with these settings. Change any of them in the tool.
How to
- Add the quiet audio. Drop an MP3, M4A, WAV or similar audio file onto the page, or choose one from your device.
- Choose how much to boost. Pick a gain of 3, 6, 10, 15 or 20 dB. Start with 6 dB, a clearly audible step for most recordings.
- Listen for distortion. Play the result and listen for crackling on loud sections; if you hear it, go back and pick a smaller boost.
- Download the louder file. Save the file, which keeps the same format as the original.
Boosting a recording that is too quiet
Quiet files are everywhere: a voice memo recorded across the room, a lecture from the back of a hall, an old digitised cassette or an MP3 whose level was never set well. This page applies a fixed gain in decibels. Start with a small boost and increase until the speech is comfortable.
The limit is clipping. A digital file cannot go above its maximum level, so if the loudest part is already near the top, a large boost will flatten the peaks and cause crackle. That is why you can choose between several steps instead of an unlimited slider. When a recording has uneven levels, with some parts loud and others quiet, a simple boost will not fix it; use the normalize page, which targets a consistent loudness, or clean the noise first, since boosting also raises the hiss.