# Shift subtitle timing

URL: https://neattrim.com/tools/shift-subtitle-timing

Fix subtitles that appear too early or too late by adding or subtracting the same amount of time from every cue.

## One constant offset, applied to every cue

Subtitles drift out of sync for two different reasons, and only one of them is fixed by a shift. If every cue is off by the same amount from the first line to the last, the file was timed for a version of the video with a different start, such as a cut with a logo at the front. A constant offset corrects that.

If the gap grows steadily, so the subtitles are fine at the start but half a second late in the middle and two seconds late at the end, the cause is a frame rate mismatch. The subtitle file was made for a video running at a different speed. A single offset cannot fix it. Check the first and last lines before you start, because this test tells you which problem you have.

The shift value is in seconds and accepts decimals, positive to delay and negative to pull earlier. Overlaps created by the move are repaired by default.

Working on the file is quick and entirely local to your browser, so you can try a few values and compare them against the video.

## Steps

1. **Add the subtitle file.** Drop in an SRT, VTT, ASS or similar file whose captions are out of step with the video.
2. **Find the gap.** Play the video, note when a line is spoken and when the subtitle shows. The difference in seconds is your offset.
3. **Enter the offset.** Type a positive number to delay the subtitles, or a negative number to bring them earlier. Decimals such as 1.5 are fine.
4. **Check the last cue too.** Then check the last line of the video. If it is also off by the same amount, the shift is right.

## Questions

**How do I know whether to enter a positive or negative number?**

If the subtitle appears after the words are spoken, use a negative number to pull it earlier. If it appears before, use a positive number.

**Why are my subtitles correct at the start but late at the end?**

That is drift, which comes from a frame rate difference. A constant shift cannot correct it, so look for a subtitle file made for your exact video version.

**Can I shift only part of the file?**

No. The shift applies to all cues. To change one section, split the file and shift the part you need.

**What is the largest shift I can enter?**

Up to an hour either way, in seconds, with decimals allowed. That covers any trim or intro offset.

**Does shifting change the format of the file?**

No. The output keeps the input format unless you pick another one.
