Remove silence from audio
Shorten a recording by cutting out the quiet stretches between sentences and saving it as audio. Recording has noise too? Run the audio enhancer first.
Runs on your device. Your file never leaves it.
Preset for this page
- Pauses
- Yes
- Audio only default
- Yes
The tool below starts with these settings. Change any of them in the tool.
Everything stays on this device. Nothing is uploaded.
How to
- Add the audio file. Drop in an MP3, M4A, WAV or other audio file. A video also works, but the result is audio.
- Choose the pause threshold. Pauses longer than your threshold are shortened. A longer threshold removes only the clearest dead air.
- Choose the amount to keep. Keep a small gap at each cut so speech sounds natural and not chopped.
- Save as MP3, M4A or WAV. The default output is audio only. Pick the format that your editor or player accepts.
Shorter audio without changing how it sounds
Spoken-word audio has a lot of air in it. A voice memo contains gaps while the speaker thinks, an interview contains seconds of nothing while a guest finds a word, and a recorded call contains stretches where nobody talks. Cutting these makes the file shorter to listen to and smaller to store, and it is a good first step before you transcribe, because quiet segments add cost without adding words.
This preset is for audio-only work. The output is a sound file and not a video, which is what podcasters, voice-over artists and people with long recordings need. It cuts pauses only. Filler words are left alone, and the sound is not changed.
Two settings define the result. The threshold is the length of silence that counts as a pause to cut. The retained gap is how much of that pause is kept, which stops speech from sounding rushed. Small values give a gentler edit, and larger ones give a faster, more edited sound.
Do not use it on music or on recordings where silence is part of the content, such as a meditation guide or a dramatic reading. Silence that was meant will be cut as well.