Removing ums and long pauses automatically
· Editorial team
You can remove most ums, retakes and long pauses automatically: the editor transcribes your video, finds filler words and gaps in the transcript, and cuts them. Upload the clip, keep pause shortening on, run the clean-up, then watch the result once and trim anything that sounds clipped.
What automatic clean-up actually does
An automatic editor works from the transcript, not from the picture. It follows four steps:
- It transcribes the speech with timestamps.
- It marks filler words such as "um", "uh" and "you know", repeated starts of a sentence, and silences longer than a set length.
- It cuts those ranges from the video and the audio together, so the picture stays in sync with the voice.
- It joins the remaining clips and exports one file.
Because the cut is made on the transcript, the quality of the result depends on how well the speech was recognised. Clear audio gives clean cuts. A noisy room, music under the voice or two people talking over each other gives worse ones.
Step by step
- Open the AI video editor and drop in your video.
- Pick the clean-up mode. This removes fillers and shortens pauses without trying to change the length of the video to a target.
- Leave "shorten pauses" on if you want dead air tightened, or turn it off if you only want the filler words gone.
- If you want something specific, add a short instruction, for example "keep the pause before the punchline".
- Run the edit and play the whole result. Do not skip this: listen for words that were cut in half and for jokes that lost their timing.
- If one cut is wrong, trim the original around that spot with the video trimmer and edit again, or accept the tiny flaw.
Check the tool page for where each step runs. Short files can be handled on your device, and larger ones may use our servers; the page tells you before you start.
What to keep, what to cut
Not every pause is dead air. A good rule is to cut a pause when the speaker is searching for a word and keep it when the pause carries meaning.
- Cut: hesitation before a word, a breath at the start of a take, a restart of the same sentence, a long gap while reading notes.
- Keep: the beat before a key point, the gap after a question you want the viewer to think about, laughter, and the pause between two topics.
- Be careful with: very fast cuts all the way through. Removing every gap makes speech sound rushed and tiring. Aim for tighter, not breathless.
Common problems
- Words cut in half. The speech recogniser put a boundary in the wrong place. Re-run with a gentler setting or fix that spot by hand.
- Fillers left in. Mumbled "mm" sounds and fillers in other languages are the hardest to catch. Run a second pass, or cut them by hand.
- Visible jump cuts. Cutting inside a single shot changes the speaker's position slightly. Add a quick zoom on every second cut, or cover a cut with a picture or text.
- Audio level changes at the joins. If the room tone is different from one take to the next, even out the volume afterwards.
Before you publish
Watch the first ten seconds and the last ten seconds again, because that is where viewers decide to stay. Then save a copy of the original in case you want to re-edit with different settings later.
FAQ
Does the editor change my original file?
No. It makes a new video from the parts it keeps. Your original stays as it was.
Will it remove ums in languages other than English?
It depends on how well the speech recogniser handles the language. Common fillers in widely spoken languages are usually caught; rare ones may not be. Check the result and cut the rest by hand.
Can I remove only the pauses and keep the ums?
Yes, in principle: the pause setting and the filler cleanup are separate ideas. If you want something precise, describe it in the short instruction box and check the result.
Is it better to cut by hand?
For a one-minute clip with a few mistakes, a manual trim is quick. For a thirty-minute talk with hundreds of small cuts, automatic clean-up saves a lot of time, and you only need to fix the few places it got wrong.
Why does the edited video sound slightly different?
Each cut removes a little room tone. If the change is noticeable, add a very light background track under the whole video or even out the volume.